I have one too.
My eyes!!!! Where’s the bleach!:gaah:
Decided I’m going to sell the Wallis tractor. Runs good, could use some minor tinkering to make it start easier. Asking $6000 and pick up only in...
I had to modify the driver’s side manifold to clear the steering shaft. I cut it apart and tig welded it together with special filler rod.
I drove that far to get an old tractor from Duffer... :D
I used all the stock components. The tail pipe could be a little better, but it works fine for what I do with the farm jeep. I can take some...
I think his jeep is a 4 cyl, right?
If you are using the stock one, it fits nicely behind the the transfer case along the driver's frame rail. I had to move it too when I put the 3...
Someone should grab this!
M-38A1/CJ-5 Ventilating Windshield Bozeman, MT $100
I just did this same swap. Some new mounting holes in the crossmember and the clutch pivot on the frame had to be moved back.
There was a discussion not too long ago about this. P/s Brackets
Not on survivors, just rusty junks I have taken apart. I can post pictures if you want.
I have seen black paint on the drums and transmission and transfer case before.
Been there, done that with the brush hog on the back of a jeep. It is a lot of work to steer! I found the jeeps work best with stationary...
Just one observation, why does a 66 with the v6 have a 70/71 clutch cable? Something is not adding up here.
I never touched my voltage regulator. All the battery cables are new and the starter was rebuilt. But the brighter lights and faster crank are...
Spend the money on an 8 volt battery. I put one in my farm jeep and what a difference that made when cranking it.
Separate names with a comma.