Only need to pack the bearings.
Turned out that, Yes. It needed a new gasket. It was old. The real problem turned out to be a bad Throttle Position Sensor.
I'm using one, works great. I would just use the sensor that comes with the gauge.
If anyone is looking for Rubber Fender Flairs. I found this. They have 2 1/2" or 4 1/2". I used the 2 1/2"....
This is my set up with the pump in the tank. I should worn you. You 're going to have to vent the gas tank or it's going to build up pressure. I...
I did the butt joint. You could sleeve it for strength.
My not be of help, but... I replaced a few sensors on my 95' TBI V-6. After the install I notices idle surging that I couldn't solve. Today I...
My Jeep has been running good for 8 years now and it's running the O2 sensor only off the drivers side. It's mounted by the bell housing.
This is my M38a1 body. I used Classic Enterprises floor supports and floor panels. Classic panels are very good quality.
The drivers side is the one at the bottom. The notch is for the military gas tank well.
My Distributor has 6 wire coming out of it.
Made mine out of 2"x2" box tube and bolted it to the frame.
I would think that the cam shouldn't matter. My TBI motor is a 95' using a OBDI computer. It has a map sensor, two coolant sensors (one in the...
Under the passenger seat is where I put my 4 way lug wrench.
Here's what I came up with. At the bottom of the bracket, down by the door channel. There is a 3/8' pin that insert's into a hole in the window...
Not even close to the problem I have. My biggest, is avoiding trees.
This was a worst case impact. I have since repaired this. I know nothing...
I used a 90 degree gear reduction at the transfer case. I needed to get the speedometer to read right.
My tow bar is "V shaped". It won't stand up vertical.
It would save damage. (y)
My window frame has been taking a beating lately. I nailed the passenger side this weekend. Drivers side on the flop the time before. Minimal...
Separate names with a comma.