Did you drop your camera in the outhouse again? :D
Rubicon prep continues
Finished the gears in front axle. Needed a case spreader to get it out :susp:
I'm getting older and remembering...
I like it, also
Hesitation is devastation...
We used that one a lot racing motocross.
(y) Let's see the numbers from these tests. If they are good maybe it is just a head swap :shrug:
Me too, I guess they just throw those in as a bonus. Gotta figure out where to put him.
I looked at mine and I'll be dipped, I don't have the plugs either and there is a small amount of fluid that has leaked onto the case. Thanks for...
That does seem like a good price.
I have the same setup, I'll go look at mine... but, is this looking front to rear on the driver side? Can't tell what I'm looking at.
Maybe I'll just go faster, you know... momentum :susp:
Fordyce has deep water crossings. August is best bet for us little wheel crowd and there is an online guide that tells you the flow rate at any...
Those are really nice. I had your comments from last years trip in the back of my mind when I made aluminum skid plates, hoping I don't regret...
Oooo! I got mail (y)
Oh, Duh! :oops:
That is so good!!!
No it’s the 470cfm Holley truck avenger. Jeep runs so good I didn’t want to stop driving it to change my front gears.
Thank you, I’ll do that. My old one was never wired either so figured I didn’t need to. I don’t really need a choke in my climate.
Yep, kinda too nice for my junk :rofl:
Somebody needs to put this thing on the front of the Jeep soon... Jeeping is exhausting and I haven't been Jeeping in two years :(
This is sound advice. I used 5/8" rod for my shifters (was going to use smaller until I saw the advice), anything smaller probably would bend the...
I'll post the final pics here also in case someone finds it useful.
Separate names with a comma.