I believe it is for the door, if there us no webbing stop on the inside. Perhaps this keeps it from smashing the fender. ????
1965 Jeep CJ | eBay
I would ask Donny or one of the other experts here.
Jeep CJ5 Willys Factory Low Back Seat Frames Original Vintage Oem Rare USA | eBay
I have a “slugger” by Fein, very similar to the one you are looking at if not the same. You will wonder why you didn’t switch earlier, at least I...
Front left drivers side. From the bend in floor rear ward
From the drivers side toward center
Mine are roughly .990 1956 cj6
If you need locations let me know
I had a similar issue. Easy outs did not work. I followed the instructions previously discussed in another thread using a torch set up to blow...
I believe Walcks has this welt. I have also seen it on ebay.
FWIW. I bought these and they had various thickness shims
DANA 18 & 20 TRANSFERCASE OUTPUT SHIM SET FOR JEEP & SCOUT 1941-79 # A-6753 | eBay
I have the 6 volt petronix version on my 56 cj6 f134 with the stock generator. I have had no issues. Also installed their coil.
Can't say it...
Just for reference these are some Goodyear Workhorse mud and snows that I picked up years ago from Nebraska tire, bias ply 700-15. They have...
Question for the electrical folks:
App: 56 cj6 6 volt with generator
At high idle, reading 6.14 at battery.
High idle: Armature to ground 7.0...
I am 10061.
So if I verify I am ten spline. Who can make me ten spline axles to fit Herm's kit? (Yes I am lazy, or tired)
56 Cj6 stock 5:38 44 rear f head
Will I have to pull the axle to get a spline count, or can I be confident it is a 19? Or the...
I have two, 64 with f head and a 56 with f head, #61 off the assembly line if I decoded it correctly.
My F134 Application. I had the same issue. Eventually had to remove the exhaust manifold so I could work on it. What I thought was clean, once...
My neighbor is trying to get his trailer up and running. He needs a lunette for a m416 trailer. Any suggestions??? Thanks in advance!
Separate names with a comma.