No, 76'-79' AMC 20 11" backing plates have a different offset built in than the Dana 44 specific backing plates.
Late CJ5's use 2" wide springs front, and 2.5" wide springs rear. Gonna be a little custom.
Cool, only 9 between yours and mine.
My advice. Call your sales rep, send the Ected locker, and the alloy shafts, and the gears back. Take your refund money, buy a 19 spline Powr...
When it comes down to $$$, and street manners, its tough to beat the Powr Lok.
Outer seal should sit flush with the backing plate when pushed in by bearing retainer.
Parts might be hard to come by. Saw that Tom's bronco had a few that I thought were priced pretty reasonably, $325-$345 complete.
Re: Whats the measurement between the spring pad locating pins on a Intermediate Dana
Anywhere between $25-$75 as a "core" TC
3"? Looks like a 33" would be perfect
Set 10 or A10 bearing.
Dr Diff in MT or WY has pretty reasonable new 30 spline side gear kits. Think they were $175 of so. Talk to Cass.
Do you have the rest of the bracket? That is 1/3 of the 68-72 Skylark bracket, but the worst part is that PS pulley... $120 something from...
68-72 Buick Skylark
1).It was there from the factory, can't hurt to keep it. 2). The stop light switch should be plumbed in using the 3 way tee included in the kit,...
Sounds like you got it figured out, pop your bull gear on and go :)
Separate names with a comma.