Put 'em in your M38A1 for goodness sake.
Engine Overhaul,Rear Main Seal and Crankshaft
There is a joint between the cap and the block. There are holes that are half in the cap and half in the block that the rubber dowels fit down...
Did you read the FSM? Section D-77 says "do not trim these packings. the packings are of predetermined length that will cause them to protrude...
That's the one I have had for many years. Motorcycle case screws.
Suggest weldingtipsandtricks.com. He has a lot of good info and videos on his site.
I did 11" fronts. Big difference, easy job.
It's a very easy conversion.
That is typical of the 9" front brakes. That and pulling to one side or the other. Upgrade to 11" front. I did it and it is a great improvement.
Glen is right about flux cored and welding outside.
The best I have used is "dual shield" Flux cored and gas. Weld anywhere, beautiful welds....
I have a Lincoln 220v MIG. I have used the 110 and think the portability is a good thing. Plug it in anywhere.
Go to your local community...
It is as Petel says in extreme cases. Bottom of the carb. It can also be seen in lesser cases by looking down the throat of the carburetor. You...
F134, 4.27 gears, 29" tires. Overdrive. Maybe 12MPG average. The problem is not the mileage. It's the 10 gallon fuel tank.
As with anything you are coating, the preparation is everything. I have had powder coating and paint both fail from poor preparation. I think...
Thirty five bucks!
So will you make me one for say $25? Using the Black Encapsulating Epoxy?
where did you find the pots? I got some used ones from Walcks.
Mine all work. If you use a brake bleeder vacuum tool on each pot, the actuate and hold vacuum. It's getting vacuum thru the control I have...
I have trouble getting the vacuum (signal) thru the control. The vac pots work ok but maybe I have a leak in the controller. Push button actuate ok.
Original stuff as much as possible!
Separate names with a comma.