Here's the skid plate bolted to the frame no tank. I welded the nuts to the frame, makes it lots easier to remove and reinstall.
Nice. I guess that jug was the fuel source. I'm flowing. (I follow all the builds)
I cut the shaft off of mine. Easier to ship. Free. If I didn’t throw it away.
I need one for my Super Beetle project. Has a very similar MC.
I have fenderwell Headers that dump under the jeep ahead of the rear wheels - between the springs and the frame. I don't get any fumes and its a...
I thought mine was a 15gal but I’ve never been able to put in more than about 12.5. Maybe mine is 13 as well???
Are new half doors available? where?
The disk is whatever came with the clutch. I have the stock t14 and a AA chain linkage. I don't think that linkage would change the geometry of...
I'm not at all happy with the clutch I have with my Dauntless. I bought the Rock Auto clutch. 1966 JEEP CJ5 3.7L 225cid V6 Clutch Pressure Plate...
Call me the guinea pig. (I've bee called worse.
I'll PM you my address.
Put on a different carb earlier this week. Today I got the choke and hand throttle hooked up, put on a new starter and cut excess off the U bolts.
I'll do that if I cant get the clearance I need with the proper fuel line bend.....and I haven't even tried to get the choke connected yet!
How big is that spacer? Got an extra?
Your carb looks just like mine. Except I have the large paper filter type air cleaner. I failed with the brake line the first time now because...
Swapping out the carb on my V6 back to a Rochester. The fitting I have on the inlet is keeping the air cleaner from sitting down correctly. Seems...
I’d tighten the linkage a tad and try again.
No way I could wait until Sunday.
If there is an "official" anything - its the cup holder.
Looking great, that one surely will be ready for the ECJ5 Colorado Epic!!
If it’s modified you got to figure out what you have first.
Stock parts are easy to find on Rock Auto.
and folks here can tell you a lot from a...
Separate names with a comma.