I use "Beaming Pix" for a picture hosting site. The price is very fair, the system work flawlessly and the owner/administrator is a pretty cool...
The boiling point of fresh water is raised approximently 3 °F for each pound of pressure applied to it.
Therefore with the boiling point of fresh...
Looks like you got it positioned pretty good, that being said... if you already have the hoses you intend to use then fit them up to the gear and...
It is a win anytime you can venture out with it and return operating under its own power.
You've come very far for starting with a pile of parts....
One way to check the shaft bushings is to warm up the engine and then while at idle spray carb cleaner directly on the shaft / bushing area...if...
If they are in the 4:10 + or - range I would go for them, $500 for the pair in good condition is very fair.
The upgraded AMC 20 should hold up...
I believe that they are factory, both my CJ3B and my C101 have them.
Here they can be seen on the C101 factory drawing, item # 4 and #26
I used grade 5 bolts, I applied anti-seize to the threads too. I chose to use the exhaust manifold gaskets on my 70.
Your body works looks great.
Okay, I went back a looked at the other picture again., that's a spectacular failure. :(
I can't help with the Dana 60 recommendation, though...
Can we see a better view of this:
Is that the cross shaft sticking through the axle?
So, your only missing one...that you know of.
I followed your build, you put a lot of time and effort into it. Do you really want to start...
Its bad in my opinion.
They are all in there for a reason and when one is missing the load is not dispersed as it should be. It would be bad...
Nice job on the "old iron", not many people can say they have a vehicle like that in their collection (y)
I did not cut the web on mine, I installed the brace attached towards the bottom of the gear.
I got out to the shop and dug up an old Luk clutch set for measurements.
Here is a used throwout bearing.
The clutch hub is about...
Forgot to ask...did you compare the new throughout bearing dimensions with the old one prior to installation?
It looks correct to me, here is a picture of mine as a comparison. This is a Luk clutch. I purposely tried to put it in backwards and there was no...
You likely have the correct seal.
The existing one is built different with the seal sandwiched between a inner & outer shield, the replacement is...
The tires look good, the 3B looks great and I am envious of your two post lift.
Yoke holding tool in action :beer:
Separate names with a comma.