I was thinking the same thing. HEI distributor and 70s air cleaner and the valve covers look off.
Here is a pricey latch, at least you can see where it goes. 1972-73 jeepster commando parts seat brackets, mounts driver and passenger | eBay
I disassembled 4 Jeepsters 67 to 71 and two had it two didn't. They were all hard top versions.
I've seen a latch on early CJs that is similar but the plate that bolts to the floor I've only seen in Jeepsters. I may have one I'll look.
Does anyone know of a good hand stapler? Putting up insulation in the new garage and am getting tired of clearing jams and misfires.
Ever think about a T-14?
Went and took a look, on the good side it had some good original parts. Seats, hood, grill, dash with all the ID plates, gas tank. It was also a...
Talk your wife into this:
Brake drum Toilet paper Holder | eBay
Guy just returned my call and it has a title. Going to look at later this afternoon. Yeah it's a M38A1 my goof in the title.
Thinking about going to look at this, not thrilled about the engine swap though.
Early 1950 Jeep
I also bought a set of these from India. The only good thing I can say is that they looked OK. They were very cheaply made and the speedometer was...
For the Jeep guy who has everything
Engine block wine rack | eBay
Hand Made Industrial Table Lamp | eBay
Candle Opera w/flame less candles | eBay
Looking good, was at this point a year ago. I believe the MC part # is 8126737
Isn't it a brake hose that screws directly into the wheel cylinder on the intermediates, Dana 30 open knuckle.
An old guy used to bring one to the shop in the 80s. They used tiny vacuum lines to engage the 4wd and were always a problem on his.
There is a used Snap on 9000# lift for sale near me. The Snap on site says the lifts are made by Wheeltronics. Anyone ever used one before?
Just got a quote from Mohawk....$8300 ouch!
Separate names with a comma.