I didn't think of that
Are there any aftermarket vendors for wheels like mine? I need a spare for the side.
Personally I would like to trade mine for a set of rims...
That is what I was looking for, thanks.
56 Willy by adams77 posted Apr 1, 2019 at 5:59 PM
Pretty solid foundation
I can build motors and transmissions and have access to a full machine...
Who here has done a frame off restoration or close to it?
I am toying with the idea of rehabing my 56 but I have no idea on what I can expect to...
Thats what I was looking for. Thanks
Unfortunately I have a Meyers top with the slight angle so Ambulance doors are a no go for me.
Has anyone seen "Ambulance" style doors on a CJ5?
Like the kind that are found on FJ40's
What about two lower hinges since my upper is going to be relocated anyway
First question on my Meyers top install.
What type of fastener for the top front on the windshield? Self tapper or does it need a nut?
Mine let go of the needle too.
I fired up the "56's unknown motor and to my chagrin... It runs. It doesn't run good but it runs!
I plan on keeping the block with carb and distributor. I might hold on to the oil bath can and carb hat. Other than that, the starter and...
Send me an image of what you are looking for.
Any benefits for swapping to this?
I picked this 134 today, I may end up using the block and carburetor. Aside from those what else should i put on the shelf? Also, vacuum advance...
If you were closer I'd make you an offer on the seat brackets, rust and all!
I splurged and bought a gas cap.
To replace the sandwich bag and rubber band.:D
I see jeeps behind every barn here in north Georgia.
I did not know that.
Thats good advice. I was planning on sleeving the hole with a bronze bushing all the way. Do you thing that would be a...
Separate names with a comma.