Warrior Products still makes corner guards. The have 1/8" steel or aluminum.
No need to flip the pitman arm tie rod.
What about 3d printing?
The 33's fit your jeep good but those wheels just dont look right. Have you concidered running 33" all terrains on the slots and 33" with a more...
I have 33x12.5 tires on 8" wide wheels and i have no complaints on how they perform on the street or offroad.
I have a sunpro tach mounted on the top of the steering column.
3/4"
No lip. The wheel opening side looks like it should have a good fit to a stock body but the back side needs a little trimming for the tailgate and...
When i was on the rubicon trip the jeep was running a little hot with all the low speed high load driving. It never boiled over but i did have to...
I swaped in a sm465 and i couldn't be happier. When driving in town i only use 2nd 3rd and 4th but on the rubicon i mostly left it in 1st and low...
Omix and crown are very hit or miss when it comes to quality especially for rubber parts. The omix t14 shift boot worked great, wasnt stiff and...
I have procomp 2.5" springs. They were very stiff until i took out one leaf from each pack and now they ride great. I didn't get them in a kit, it...
Notching the rear wheel well housings to be able to move the seat back a few more inches is a popular modification and almost mandatory if your...
Mine looks similar to yours. I think i have mine moved back 4" from stock. Im 6'7" and my knees would be up against the dash if i didn't go that...
The only way to know for sure is to measure. Novak has a good article about measuring the clutch and bearing in their tech articles section.
500 pounds seems a little high. I took the body off with the help of one other person and I was able to move the body around in my garage by...
Thanks They are empi seats. They are made for old VWs and sand rails. Yes the wheel wells are notched.
I made some progress over the last couple of weekends. The throwout bearing was binding with the new AA clutch fork and was just a hair too long...
Steering Box Clamp I used this clamp with a couple heim joints and some dom tubing.
I made mine like tarry99s but i bought a steering box clamp from M.O.R.E.
Separate names with a comma.