You might want to check ATP Automotive .
There could be A snap ring on the end of the axle You will need to remove . This will not effect the wheel bearing
adjustment. Although if it was...
The Front Engine Mount is An After Market Item.
The one on the right looks like an early 1950's chrysler wheel.
My Application book shows they are both the same , National 99155 or Chicago Rawhide 99155 .
I use BWD Brand Part # PCV918 , From O'Reilly's Auto Parts , My Jeep is A 1974 Jeep CJ5 with 258 Engine.
I hope this helps .
You could check with Vintique I have them on My 1974 CJ5 , Part number 62-585504 , they are set up for hub caps
but I don't know if Your hub caps...
Have You ever tried Blair Rotobroach cutters , they do A great job . You can hook Your light up to the dimmer switch
then the light will come on...
These are still made By 1st Gear Offroad , Phone # 951-654-4532.
Would You do the GEO disc front over again ?
Looks like it sets to low ?
Run 30 WT Quaker State with A pint of STP. Have used this for 50 Years Plus with no problems.
Let Us know how they work out.
Use an air gun and blow the dirt out from around the spark plugs. Wear safety glasses to keep the dirt out of Your eyes.
Just Be careful with the...
I have been there and done that.
2- Timken 24780 Cone
2- Timken 24721 Cup
Inner 1- Timken 31594 Cone
Inner 1- Timken 31520 Cup
Outer 1- Timken...
The manual shows that the front and rear wheel bearings should be cleaned and repacked every 12000 miles.
For Years 1971 to 1973.
The seal is on the knuckle.
Yes , clean and repack the king pin bearings with new seals , and clean and repack the wheel bearings with new wheel seals .
Separate names with a comma.