It is the Currie antirock, only one the right width for our early jeeps. This also drives the sway bar diameter - which is why I am adding some...
Have a dana 30 wide with the following new parts (not assembled) Only the housing/ R&P is not new
All prices would be plus shipping........
Suggest someone did this
Rear Dana 60, offset 35 spline 1.5” diameter axles, semi float
Adjustable sway bars, links easily removable
Rear disc brakes w...
[ATTACH] [ATTACH] [ATTACH] As noted I moved the column from the stock M38A1 location when going to saginaw steering. Used a later model mount,...
Can you provide more pictures of your implementation?
Will grab some pictures with header and steering linkage held in position in morning (not finished yet w my tilt column from a later CJ,...
[ATTACH] Got the replacement header, fits beautifully!
Super support from Novak!
Note old non fitting header that hit motor mount in reply #22
Years ago I replaced the broken spring hangers on my 68 Commando with Ford Ranger hangers - which for some years also used a mono leaf spring with...
Thank you, located where I would expect and shows it will work with the right passenger side!
More discussion and emails
Kudos to Novak,...
Had to resend the emails/photos - as of today now in Eric’s hands, hopefully decision soon!
I think your pictures (sent him a link) are the reason they are reconsidering!
Thank you !:bow:
They asked for more pictures and Eric thinks I may have wrong headers - possible light at end of tunnel!:)
Bought a 1953 M38A1 with unfortunately a Buick 198, the drivers mount and a mangled passenger mount. (Same mounts) dropped from military service...
[ATTACH] Pic of frame mount
[ATTACH] [ATTACH] I have factory v6 frame and rubber mounts.
Have tried both sides on the drivers side and the collector is less than an 1/8”...
Tried the alternate (somewhat different shaped) engine mount and it is slightly better.
Header still will not fit in place - factory engine mounts...
Current design as sold by Novak and made by Sanderson has both sides mirrored- placing the passenger collector output right over driveshaft...
The headers have arrived!
Spent first week working out the steering - all fits w a few adjustments.
Finally tried the passenger side and it does...
Any chance someone has a 3D printer to be able to make these?
Separate names with a comma.