I got a couple of old but good ones from Walcks.
where did you find the pots? I got some used ones from Walcks.
Mine all work. If you use a brake bleeder vacuum tool on each pot, the actuate and hold vacuum. It's getting vacuum thru the control I have...
I have trouble getting the vacuum (signal) thru the control. The vac pots work ok but maybe I have a leak in the controller. Push button actuate ok.
Looks like very nice work.
Original stuff as much as possible!
[ATTACH] SEM Trim Black. #39143 (I think). From automotive paint store. Nice satin finish, good hiding, tough and once dried, resistant to...
Steele Rubber has all those extrusions and locking strips.
Also why I do business with them. They are the best I have dealt with for new stuff. Midwest Willys for used parts
I just called the above supplier and his tabs are from Walcks and are .0735 thick. Nice fellow.
I had not seen those. They look just like the Walcks tabs. I will call and find out the thickness.
If anyone needs the milling done to some Walcks tabs, I will do it for return postage. (insured?)
Sure, but it takes up floor space.
Mine carries the load to the rear crossmember. Top is only fore and aft loading
YES! I copied yours. Here is what I did at the ends. Mine is different.[ATTACH]
[ATTACH] Here is how it came out. I now have a hardtop on and the tire and rear door interfere with each other. There are tabs on either side of...
For some reason I am having trouble uploading as it says file is too large. Will work on it.
I got one from Daytona Parts
[ATTACH] Here is how I attached mine. Can be lifted off.
Lockmans motto " He who dies with the most Tools... Wins !" deserves discussion. I think I will start an off topic discussion. I am getting...
Separate names with a comma.