Why not give it a try.
I've ran a couple 283's years ago in cars. They are great engines. Check your compression, and if good , my advice is to hang on to it.
I know in a n14 that rotella works great. My dump truck had 495,000 miles when i sold it i usually left it one gallon low to add a gallon of...
Greetings to the forum
I like the springs under the axle. There are arched springs that you can purchase to get a higher lift if you want.
Sorry to hear of the leaks, the engine builder should make it good
Aftermarket wheel there. Can fit 4wd ford, internaional, or jeep. Your local tire store should be able to help
Welcome from northeast georgia. Agree the shocks may be to blame. The angle the shocks are may contribute some too.
Went with the rv cam in my 304. It made a big difference espcially below 2000 rpm
Enjoying your build on tranny. Look forward to your future post.
Welcome to the jeep family.
That is really cool. Now that's innovation....!
Antisieze is never a mistake in anything used outdoors. Believe it, but stainless will actually rust under some conditions. Especially if you use...
I never used a clutch to shift gears in my dumptruck transmission. The clutch was only used to put it in whatever gear i wanted to start in. It...
The new 5 speed that mahindra uses in their roxor might be an option
Welcome from northeast georgia
Just because it has a new fuel pump, doesn't mean it is good. New parts today can be a problem.
I run an electric pump in line with the mechanical. Electric pump has a switch to cut off once cranked and prime picks up
Love jb weld. Used it even on fuel tanks, it works
Separate names with a comma.