In the US it’s made by Mico. I did a search and a bunch of companies sell their products.
Pics won’t load for me
Good guess, July of 1962
Most truck dealers would know what a matched set of belts are.
Grade 8 bolts are usually black oxide coated and rusted pretty fast.
When I put the 11” brakes on the front of my ‘61, got everything from Rock Auto. Just about $200 but a lot of that was shipping. I’m sure if you...
Smaller master cylinder would be an improvement. Is there a proportioning valve in the system?
I’m guessing it’s holding oil. Looks nice and clean in that area.
Fiberglass is even easier. No welding. You can get cloth and resin at most auto parts stores. Good luck and post up pics of the progress.
Hanging pedals. Both the brake and clutch master cylinders are up and out of harms way as well as freeing up a bunch of real estate below for exhaust.
My restoration/modernization took a fair bit of my time as my family and I did 99% of the work. The cost was spread out over those years so not...
Is that a CJ5.7?
If you push down on the pushrod end of the rocker arm the lifter should bleed down after a reasonable amount of time. If they are solid, no...
Just because your engine is mounted off the front doesn’t indicate an early engine, however the lack of side mount pads would. Should be a...
I looked back through your pictures to see what Jonyboy was talking about. Factory shroud but not the original radiator. There is a gap around the...
I like it. Looks beefy!
I bet a well fitted fan shroud would be enough to cure the need for the auxiliary ugliness out front.
Well said Alan.
Move the excite wire to the accessory post on the ignition switch. This should separate the two circuits.
Separate names with a comma.