I want to get moving on power steering for Tonk. I'll be using a ram assist setup like Nate is using.
I have a pump setup that fits onto the...
For an F4, Sealed Power or Melling?
Anyone able to tell be the specs on the spring packs? I.e. leaves, eye to eye lengths, width?
Anyone have a source for stainless studs to fit a F4? All I can seem to find are kits containing twice as many studs as I need in one size only,...
[ATTACH] [ATTACH] [ATTACH]
*SO* many buttons o_O
So I was headed into work a few weeks ago & since it was a nice day I was taking Tonk. :)
Decided to take the highway for a change & about 2...
The brake reservoir I built for Tonk sprung a leak. Specifically the aluminum plate in the bottom (that the lines connect to) which was epoxied...
I'm blowing these things out like crazy :(
I think the issue is that I had a stainless exhaust system installed & I think that it vibrates more...
Regular $240 on sale for $89-
Anyone got a pic of one of these things, hopefully showing where it mounts & what style connectors they use?
I'm trying to figure out if a late...
Was there ever, in any application Jeep and/or otherwise that anyone here is familiar with, ever a Dana 44 19 spline axle that did not use a...
And that's after you just rebuilt it???
Stumbled across this
1st Gear Off-Road - Products
Listed for a...
Got a leak where the pipe joins the manifold, actually two- mid point both sides but it's worse towards the driver's side.
Pipe is 1 1/2"...
Anyone have a bearing manufacturer part number for the Prestolite generator front bearing?
Anyone here running a toyota starter? I'm curious as to how long they are from the face of the flange to the back cover. Anyone able to give me...
Recommendations? The accordion style one I bought last year from Walcks is trashed already, cheap rubber & too much stretch in 4-low.
Well, I took Tonk out for a shakedown cruise the other night just to see what was going to break. :roll:
Got about three miles running fine &...
Finally- We're Mobile-
I'm in the market for cable for Tonk's PTO Ramsey 200. Ramsey says 140' of 3/8" is what's required however I'm at a loss to know which cable is...
Separate names with a comma.