Fly and Drive adventure!
Vbracec by sdcj6 posted Jun 23, 2019 at 6:38 PM
Right angle bracket bolted to draw bar
Vbraceb by sdcj6 posted Jun 23, 2019 at 6:38 PM
Apparently I am wrong on the welding part. The drawbar end was welded to a piece of right angle steel that then was bolted to the upper 2 drawbar...
On my 71 CJ-6 with rear fuel tank the V bracing was not vertical as the earlier Jeeps and the replacement shown. The bars were flat stock, I...
Marine Corps trailer
Gas can mounts welded to side of frame
Loops front and rear are for airlift by helicopter
Motor is reversible.
Ratchet style brake but not a drum, flat disks with radial fins. Clock works style dog on center plate.
It kept the patio concrete from flying off into space
The brake is like the later model and the motor is directional
No, it's an 8200. precursor to the 8074.
It has power in and power out.
Truck Motor9small by sdcj6 posted Jul 4, 2018 at 2:36 PM
I drive mine every day. When it had a Dana 18, I would have to change the shaft about once a year. Southern Cal. freeway speeds probably killed...
About 850lbs. for 35 miles.
Trailer Today2 by sdcj6 posted May 28, 2018 at 2:28 PM
More like 1 1/4 Jeeps. I used the back CJ-6 half to a Cj-5 front half and used the later long hood and fenders.
The old frame and other parts...
I noticed that when we are driving around looking for ditch chickens the Dodge truck has the A/C on and I am eating dust and overheating
[IMG]floor11 by sdcj6, on Flickr
Underside of the rear half coated
[IMG]floor7 by sdcj6, on Flickr
Glad I am not the only one with a collection like this.
Added more photos
Some have asked about updates on the old "6"
Adding more photos, modification descriptions.
lets see if this works.
Starting point teardown...
Use lock tite instead of Teflon.
Separate names with a comma.