Willys 4 X 4 Locking Hubs
Might have to get these.
Use a pump like I used that has a remote reservoir. You should be able to leave everything stock and make a mounting bracket.
What about mounting the pump above the generator and getting a double groove generator pulley to run the pump? That way your crank pulley is open...
They are the same front and back.
See here: Source For Quality Axle Dust Covers
I would post a WTB ad for some originals in good shape.
Certainly wasn't aluminum and didn't look like it was galvanized to me. It may have had a primer on it.
I was all hot about a gladiator, went to the local jeep dealer and built one. There are a few cheesy things I don't like about the gladiator,...
I have a FB, but never use it. People post things there and people comment. I never look. I only go on marketplace. My craigslist is dead now. I...
This jeep is clean for new england standards.
1974 Jeep CJ-5
Hmmm... not too far from me. :D That sure would look good in the back of the farm jeep.
Front Wheel Drive Flange Gasket Fits 41-71 Jeep & Willys
I had no trouble finding the gasket. This will work on a D30 with 6 bolt hubs.
It could be a broken spring in the friction disc. My jeep had that happen and it would shudder like crazy when taking off.
Lots of corvettes and mustangs without engines apparently? :confused:
M151's are unibody, so he must have done some major hacking to put the 4x4 frame under it.
A three point hitch.
Sadly, someone will buy it hack it up. :( I hope it will be saved though.
I'd say that is a good price. Those recoiless rifles aren't cheap and they are difficult to come by. I see it also has the spotting rifle with...
Separate names with a comma.