1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

And a whole lotta holes

Discussion in 'Early Jeep Restoration and Research' started by quailtbird, Apr 17, 2006.

  1. Apr 17, 2006
    quailtbird

    quailtbird New Member

    Tallahassee, FL
    Joined:
    Dec 31, 2003
    Messages:
    6
    I have just purchased a '71 CJ6. Numerous, I am sure, previous owners have drill holes in the body and floors to attach all sorts of stuff. I would like to fill in the holes before I repaint it.

    My questions is what is the best method to fill in the holes? I don't see how they can be welded up because you can't weld just thin air!

    I thought maybe fiberglass patches on back side or epoxing small steel patches.

    Oh, one more. The aforementioned previous have also drilled the dash board many times and installed non-stock gauges. Any ideas on where I can buy a replacement dash panel?

    Any suggestions will be appreciated.

    John
     
  2. Apr 17, 2006
    neptco19

    neptco19 That guy....

    Athens, GA
    Joined:
    Sep 26, 2003
    Messages:
    1,381
    Depending on the size of the holes you can use a piece of copper or a brass punch on the back side of the hole and weld it up. Then grind it smooth. For the bigger holes you can make little patch panels to weld in.
     
  3. Apr 17, 2006
    mb82

    mb82 I feel great!

    Charlottesville Va
    Joined:
    Mar 17, 2003
    Messages:
    2,706
    Put a thick piece of Brass or copper behind the hole and hit it with a mig welder, you will fill in the hole quickly. I did this on my grill in a few small rust holes and after grinding down the weld you could not even tell it was there.

    Edit: Jason was faster on the draw then me.
     
  4. Apr 17, 2006
    70CJ5

    70CJ5 Member

    Pleasant Hill, Ohio
    Joined:
    Dec 11, 2004
    Messages:
    114
    I use a chunk of Alum. instead if copper or brass. It works good too.
     
  5. Apr 18, 2006
    quailtbird

    quailtbird New Member

    Tallahassee, FL
    Joined:
    Dec 31, 2003
    Messages:
    6
    Thanks for the suggestions. I got lots of welding to do!

    John
     
  6. Aug 1, 2006
    RustFree72

    RustFree72 A work in progress

    Longmont, CO
    Joined:
    Jul 27, 2006
    Messages:
    36
    What about Lab-Metal? Its a liquid that hardens to metal. I've got a similar situation with holes in my '72. Anybody have any experience with the Lab-Metal, or should I try welding?


    -72
     
  7. Aug 6, 2006
    Rampdog

    Rampdog knuckle buster

    Sandy, Oregon
    Joined:
    Mar 27, 2006
    Messages:
    105
    I've never found a liquid that would transform itself into metal sufficiently enough that I'd trust it. I have used different epoxy type compounds, but only where with they wouldn't flex out and fail. I've never heard of lab metal, so it may be something to consider.
    Try the welding, I think you'd be better satisfied with the results. JMHO.
    Mike
     
New Posts