1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

How To Determine Replace Vs Clean/repack

Discussion in 'Jeep Trailer Tech' started by mickeykelley, Apr 9, 2022.

  1. Apr 9, 2022
    mickeykelley

    mickeykelley Well-Known Member

    Republic of Texas
    Joined:
    Oct 10, 2015
    Messages:
    1,900
    I’m in the process of going thru the hubs on my Bantam T3-C in preparation for a camping trip this summer. I have no idea of the history of maintenance on it. I pulled everything today and to me they look fine. No marks on the races, nothing loose or broken and no excessive leaks out of the rear seals. In fact nothing even really what I’d consider fresh and I’ve pulled it probably 3,000 miles, much of it at 70-75. I haven’t yet really cleaned the bearings but a good wiping they look fine. When I have pulled it, I stop and feel the hubs fairly frequently and have never felt any heat. The inner bearings could have used some more grease but still looked good, just very dark. The outer ones had plenty of grease and that is probably due to at some point a PO added a jerk in the cap. Not sure if it really gets grease in the bearings that way, especially the rear one, but it was full of fresh grease including mine. They are Timpkin made in the USA so probably older ones when things were made better. Thoughts on clean, inspect and repack if no marks or flat spots on bearings, vs replace with new.
     
  2. Apr 10, 2022
    Jw60

    Jw60 Sitting up n buckled down. 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Sedalia MO.
    Joined:
    Apr 8, 2008
    Messages:
    4,716
    I'ld repack and move on. The bearings on a tc3 are huge compared to what's under my 3500lb camper. They are the same as the dana 25 but don't stop, steer, or carry much weight (half the time unloaded)
     
    Ol Fogie likes this.
  3. Apr 10, 2022
    3b a runnin

    3b a runnin Active Member 2023 Sponsor 2022 Sponsor

    virginia
    Joined:
    Jan 11, 2015
    Messages:
    1,290
    You probably have better bearings than you can buy today.
     
  4. Apr 10, 2022
    mickeykelley

    mickeykelley Well-Known Member

    Republic of Texas
    Joined:
    Oct 10, 2015
    Messages:
    1,900
    These were my basic thoughts and last night I decided to do just that. Just new rear seal and nuts that had the typical gouges from PO's not using the proper tool.
     
  5. Apr 10, 2022
    oldtime

    oldtime oldtime

    St. Charles,...
    Joined:
    Aug 14, 2006
    Messages:
    3,466
    Right if they even look to be in fair condition then they are still good for many thousands of miles. Cleaning and repack is always good. In fact the only way to determine exact condition is via full cleaning and inspection.
     
    Ol Fogie and ojgrsoi like this.
New Posts