1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

John Deere Resurrection

Discussion in 'Builds and Fabricators Forum' started by termin8ed, Sep 4, 2020.

Page 2 of 2
  1. Sep 13, 2020
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    [​IMG]
    Need to make a new adjusting arm. Had to take the sheet metal off to get good access. Really should take the radiator out but being really carefull and think i have the room i need now
     
    termin8ed, Sep 13, 2020
    #21
    Fireball likes this.
  2. Sep 13, 2020
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    [​IMG]

    Adjustment bracket almost done. Connect the dots tomorrow at work where i have my cut off disk
     
    termin8ed, Sep 13, 2020
    #22
    dozerjim and Fireball like this.
  3. Sep 14, 2020
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    Well, would be going back together but trying to find a good spot to tie into for the alt. Not sure how this thing hasn't burned down yet.

    [​IMG]
     
    termin8ed, Sep 14, 2020
    #23
  4. Sep 19, 2020
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    Back together today.

    [​IMG]

    [​IMG]

    [​IMG]
     
    termin8ed, Sep 19, 2020
    #24
    bigbendhiker, Snoops, blalp! and 2 others like this.
  5. Sep 20, 2020
    Fireball

    Fireball Well-Known Member 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Pullman, WA
    Joined:
    Feb 9, 2018
    Messages:
    5,688
    The tin is sure in nice shape on that thing.
     
    Fireball, Sep 20, 2020
    #25
    blalp! likes this.
  6. Sep 20, 2020
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    [​IMG]

    The recessed area on the hood behind the john deere lettering, the paint has buckled and lifted from the primer. Had a bunch of water sitting behind the paint like a blister. I popped a hole thru the paint so it would at least drain. Most of the 20 years I've had it, it was under cover after a restoration 22 years ago. Its the last 4 its been outside. Need to get it covered up again.
     
    termin8ed, Sep 20, 2020
    #26
    Fireball likes this.
Page 2 of 2
New Posts