1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Ebay Floor Panels

Discussion in 'Early CJ5 and CJ6 Tech' started by Shopteach, Aug 4, 2020.

Page 2 of 2
  1. Sep 1, 2020
    truckee4x4

    truckee4x4 Grant Kaye 2023 Sponsor 2022 Sponsor

    Truckee CA
    Joined:
    May 30, 2008
    Messages:
    1,322
    @Warloch question for you - when you spliced your Classic ent. floor panels in with the transmission tunnel “arch” panel between them, did you do an overlap or a butt joint? I’m making a template to cut the Classic panel and needing to decide on an approach. Shown here upside down on rotisserie:
    14A72340-8DD5-4FF5-8C07-0457057BFE9E.jpeg
     
    Last edited: Sep 1, 2020
    truckee4x4, Sep 1, 2020
    #21
  2. Sep 1, 2020
    Keys5a

    Keys5a Sponsor

    Florida Keys
    Joined:
    Jan 23, 2014
    Messages:
    4,190
    When I have done this floor pan work, I've left about a 1/4" of the flat part of the original floor adjoining the hump. This gives a small lap joint that I find easier to weld with a little higher amps for solid penetration without burning through.
    -Donny
     
    Last edited: Sep 1, 2020
    Keys5a, Sep 1, 2020
    #22
  3. Sep 1, 2020
    scott milliner

    scott milliner Master Fabricator

    Seattle Wa.
    Joined:
    Dec 17, 2002
    Messages:
    2,362
    I did the butt joint. You could sleeve it for strength.
     
    scott milliner, Sep 1, 2020
    #23
Page 2 of 2
New Posts