1970 Jeep Clutch Fork Boot

I am looking for the right clutch fork boot for my CJ. It's in the bell housing from '70, in front of a T14. Just need source of supply.
Thanks!
Joe

 

Did you try any of the vendors in the "where to find parts" sticky at the top of this section?

 

Yea, unless I'm missing something the vendors seem to list mid to late seventies not '70-'71. I know it is different than my '69 bell housing, it's much larger.
I'll call Herm, he lists a GM/V6 boot, just no application description or picture.

 

AA or Novak has them with picture, I forget which.

 

Picked mine up at NAPA but that was years ago.

 

I had thought only the '71 is an oddball bell. '66-70 should be a plain GM BOP bell. The '71 was different because it included the adapter as part of the bell housing.

It's possible that the boot for the AMC bell (T-14, T-15, T-18) would work. No PN here at work ... later if you can't find it.

 

Does a 3173646 look like it? http://thejeep.com/shop/HARD+PARTS/...H+FORK+BOOT:+1972-75+JEEP+CJ+6+OR+8+CYL..html

 

The boot on my 71 is 4.25" wide and 3.75 inches tall. I have not been able to find a replacement.

 

I do know the bell housing from my '69 was short and has an adapter to the transmission. The '69 has a small boot. My replacement running gear is supposed to be from a '70, the bell housing is one piece, and the hole the fork is in is huge (4.25 x 3.75). I'm still looking. I wish vendors put measurements with their pictures.

 

Here is one for a BOP bell housing and it does give size. 2 1/4 X 3 1/4
http://www.ebay.com/itm/360032685898?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

Andrew

 

http://www.advanceadapters.com/products/buick-bellhousing-boot/
Check here. This fits my '70.

 

Thanks! Looks like this one will work. I'm ordering it and will comment on fit when it gets here.

 

This one fits the opening in my 1971 V6 bell housing, but I had to modify the clutch fork opening. It isn't a complete seal, but it is the only one I could find to fit the 1971.

http://thejeep.com/shop/HARD+PARTS/....html?osCsid=457bc485a5a540cb2464724db36a73ef

 

I bought a couple OEM NOS boots from Kaiser Jeep but they were not cheap.
Cost me like $75 a piece.
They are much thicker constuction than any of the modern repops.
I may decide to sell one of them someday.

 

$75 a pop!