Exhaust for a V6 CJ6....

Anybody had experience with a Waldren Exhaust system?

http://www.waldronexhaust.com/

 

Be aware that is for a stock system. No Saginaw steering or rear gas tank mods.

 

Thanks, understand. I am going back as close to stock as I can get it, so may give them a try.

 

Does anyone have pics of how the stock V6 exhaust was routed? I would love to get rid of the mufflers hanging off each side of my Jeep, but me or the muffler shop can't figure out where to run it.

 

I can get pics tomorrow of stock exhaust for a cj5 if no one has any before then.

 

There is a diagram in the FSM IIRC. Can post tomorrow

 

Here is the scan from the FSM.



Hope the helps.

 

That helps a TON.

So the it went down below the frame then? Hmmm. I think i'd end up flattening it with the stuff I do. Bummer, i'll have to stick with the side exhuast setup.

 

My cross over pipe was redone, and hangs at about the same height as the transmission crossmember.
It got eaten pretty good at Calico.... I wouldn't really recommend it for serious trails.

Of course, the exhaust shop also put the new muffler next to the gas tank....

(the wonders of POs)

 

I had my stock system redone at a local muffler shop after tearing up the original on Rubicon during the '11 trip. The tech was able to route the exhaust over the top of the transmission crossmember instead of underneath like the factory did. Other than that he followed the original routing. Good clearance and it sounds great, he charged me $311.

Don