I would agree that swapping out the knuckles is the easiest way to change the front drums to discs but also be aware that you will need to have a...
If the engine is an AMC there will be a designation on the block that will tell you what size the engine is.
The pump is driven by a cam that is on the front of the camshaft
I have 3.73 gears in my 72 with the T15 and 70mph is no problem I think that I'm around 2800 at that speed. I'm running 235/75/15's
Dne' When I painted my 72 which has a glass body I was told the only thing special I needed to do was make sure I used a sealer on it. Something...
You would be better off bringing it in there were multiple calipers around that time that were used
I had the same issue with teeth being ground down. Replacing the gear is really quite easy if you have access to a torch. It took maybe 15...
I definitely agree that the windshield and door window frames need to be black and I would add that the roll bar would look better black as well....
Not sure what you have going on but my 72 has the same drive train and gearing and I'm less than 2000 at 55mph. At 4000 it would be really be...
I have replaced both shafts with ones I bought from Tattons. I have been very happy with them nice quality and much larger then the originals....
I found the knuckles from a newer D30 that had disk brakes was an easy swap. I could never stop straight with the drums up front never knew which...
Check with a local NAPA store many can fabricate the high pressure lines. The store I worked made those hoses all the time for the guys here for...
the flat piece is the support for an oil dipstick. The small hole is used for a valve cover bolt to hold in place and the large hole goes over...
You might also check the coil they go bad as well and can be affected by RPMs. Also remove the dist. cap and see how much slop you can feel that...
I have that same loop on my 72 and the 304 I have is original
Separate names with a comma.
