I'm looking for the correct tube length measurements to cut/modify a D30 tie -rod set up towards implant on a "stock configured" early CJ > D25....
When you get a chance, post some pics of the Engine bay. Also, check with Brent (Mullinsjeepparts.com) in TX. I think he still has a few NOS...
Hopefully, not an exceedingly expensive hole..
Originally as an ambulance, it housed the spare tire, Fuel can and axe.
Not only did you land a rare M170, this version Radio conversion was used for the Marine Corps. and is designated AN/MRC-87 !!!:shock: VERY FEW...
man, I'm thinking, where the heck did you find another 192 block? you got lucky!! was it a salvage pull from a Massey F?
Midwest Military Army Jeep Parts Debella Jeep parts Walck's
if any of the above suggestions don't pan out, bench test the switch with a V/M and check gradual resistance by blowing compressed air from 0 to...
have you tried re-torquing the head bolts to spec? Any bubbles (percolation) noticeable in your radiator when motor to temp? should the gasket be...
X 2 ... a 1/2" drive impact wrench should do it.
Can you provide a pic of the passenger side and view of the Tailgate?
When Posing a Quest such as yours, we need a little more historical background/Symptoms to assess and hopefully be able to assist in properly...
x2:coffee: not to mention, better highway mileage and less rpm means less taxing on the motor to keep up with Highway speeds (most often with...
maybe a spring loaded -3 stone cylinder hone tool. I'm sure one can make it work and just get the course grit (30 g?). Its designed to stay...
Separate names with a comma.