I vote not a chance. Just drill and tap it. You can try heat and weld a nut on but I wouldnt chance breaking off an ez out no way. You are taking...
I think it gets more liquid the hotter it gets so maybe it wicks in a bit then. After its too late
Yeah I have some of that old stuff its like thick paste. Id much rather use new stuff it moves around better. I usually do wheel bearings once...
Well if you put the thermostat in upside down it will push it open and take forever to heat up.
New upgrade, that possibly nobody ever wanted! | ECJ5 (earlycj5.com) Some info on the fan clutch. Some dont have any room for one. The rad is...
And the key goes tapered end in first and tword the shaft to correspond with the cut on the axle. But it isnt that hard to pull the axle and check...
I would drill it too small and wallow it out till it fits good. Its not a critical thing anyway. Are you worried about balance? How fast do you...
Yesterday I swapped the horn for an old Ah-Ooga horn. Just for kicks its very funny! And today I installed the power-lok. I tested the breakaway...
I put an ahh-ooga horn on my fc. Its fun cant wait to honk at people now. I have a power-lok for it Im probably going to put in this week. I have...
I have like 4 sets of channels made I will sell. I also make the upper hinges but dont have any at the ready but I have time maybe this week ill...
Second test ride today works pretty good had a fuel leak pulled the tank off to fix. I guess i need to tighten the chain aswell. Very happy with...
Separate names with a comma.