Anyways I was talking to a guy I work with has a couple of 25s out of Willy’s wagons. You think it’s a direct drop in or would I have to weld...
I heated up a screwdriver with the torch and bent it and stuck it in there and still can’t get it to budge
Im about to jam some metal between the chunk of shaft stuck in there and the cross pin and the other shaft and just weld it and find a 30 to put...
It snags at the bearing in there. Tried pushing the cross pin out so I could take the gears out try going through the carrier but it won’t budge...
I did use a screw driver to push it in a ways but not far enough.
I’m not sure how long the piece in there is, I think it should just be the thing splines but I don’t know how long that piece is. How difficult is...
I can’t get it out even with the magnet. I think the magnet is catching up on a bearing in that end before I get it in there to where that chunk...
I’ve got a stick of rare earth magnet that will fit down there. I’m gonna try to get it out with a wire coat hanger before i stuff that in there...
I got it off of there. Wasn’t all that tight and backed off after one hit with the hammer and screwdriver. Got the spindle and one piece of the...
I found my problem. there indeed is a washer I was confusing for the bearing and once I pulled it out I found another nut. So what size is the nut...
I removed the nut I assume is the inner one, it was a 2” OD and it didn’t have the outer nut on it for some reason which should be smaller and...
I’ve been trying to upload a photo to show you what I’m talking about but it says it’s too large.
I got the drum off no problem, it’s the hub the lug bolts go through I can’t get off
I put the 3 jaw gear puller on there and it comes off maybe half an inch then if I back the bolt off it goes back into place where it was. It’s...
The only one of those I see in there is the bearing. Do I need to pull it out before the hub will come off? And if so how do I do that?
Separate names with a comma.
