1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by Abone327

  1. Abone327
    Post

    Oil Collecting On Engine Side Of Flywheel

    I don’t think there will be an issue with rtv going through the engine. I am more concerned with any rtv remaining in the rms channel causing a leak.
    Post by: Abone327, Jan 17, 2020 in forum: Intermediate CJ-5/6/7/8
  2. Abone327
    Post

    Oil Collecting On Engine Side Of Flywheel

    Thanks Tim
    Post by: Abone327, Jan 14, 2020 in forum: Intermediate CJ-5/6/7/8
  3. Abone327
    Post

    Oil Collecting On Engine Side Of Flywheel

    Thanks everyone. I’ll try the pipe cleaner first. Is there a solvent I should use to help break the rtv from the block? I’m having a difficult...
    Post by: Abone327, Jan 14, 2020 in forum: Intermediate CJ-5/6/7/8
  4. Abone327
    Post

    Oil Collecting On Engine Side Of Flywheel

    Yes. I ended up pulling the cap and found that it is the rms leaking. The problem I have now is that the engine builder used rtv in the seal...
    Post by: Abone327, Jan 14, 2020 in forum: Intermediate CJ-5/6/7/8
  5. Abone327
    Post

    Oil Collecting On Engine Side Of Flywheel

    I got the dipstick and tube from bulltear.
    Post by: Abone327, Jan 13, 2020 in forum: Intermediate CJ-5/6/7/8
  6. Abone327
    Thread

    Oil Collecting On Engine Side Of Flywheel

    I have a fresh, zero mile, reman 360 that I just put in my Jeep. I ran it for 20 minutes for cam break in with no oil leaks. Before shutting it...
    Thread by: Abone327, Jan 11, 2020, 16 replies, in forum: Intermediate CJ-5/6/7/8
  7. Abone327
    Post

    Open Engine Advise Please

    So after checking some bearings I've decided to do a rebuild. Tim, I have purchased the book that you suggested. I have the engine torn down and...
    Post by: Abone327, Jun 29, 2019 in forum: Intermediate CJ-5/6/7/8
  8. Abone327
    Post

    Open Engine Advise Please

    The heads weren’t/aren’t removed. I don’t have a problem with installation or removal of the engine from the Jeep. I don’t however have any...
    Post by: Abone327, Jun 10, 2019 in forum: Intermediate CJ-5/6/7/8
  9. Abone327
    Post

    Open Engine Advise Please

    Now I don't know what I'm going to do again. I guess I've got some thinking to do. I'm don't know what all is wrong with the 304. It has low...
    Post by: Abone327, Jun 9, 2019 in forum: Intermediate CJ-5/6/7/8
  10. Abone327
    Post

    Open Engine Advise Please

    Thank you. It is tempting to throw it together and run it. Feels like my Jeep has been down forever. I think that I would be more comfortable...
    Post by: Abone327, Jun 9, 2019 in forum: Intermediate CJ-5/6/7/8
  11. Abone327
    Post

    Open Engine Advise Please

    It's replacing my original 304 which has taken a complete dump. I thought I might get away with purchasing a runner and upgrading to a 360 for a...
    Post by: Abone327, Jun 9, 2019 in forum: Intermediate CJ-5/6/7/8
  12. Abone327
    Post

    Open Engine Advise Please

    I guess my post was a little confusing. The engine that I have and am using and am inquiring about is an AMC 360. The guy I bought from is going...
    Post by: Abone327, Jun 9, 2019 in forum: Intermediate CJ-5/6/7/8
  13. Abone327
    Thread

    Open Engine Advise Please

    I purchased a 360 that had been pulled to re-gasket but then they decided to replace it with a chevy. He said it ran well and didn't have any...
    Thread by: Abone327, Jun 9, 2019, 19 replies, in forum: Intermediate CJ-5/6/7/8
New Posts