I was told that TA Performance had a design that didn't use the pins. But someone else said it was the same as the Felpro. I ordered one just to...
They seal the rear bearing cap to the block. [img] [img]
I'm following this as well since my 1 year old rebuild is leaking already. From what I've read, it seems the most problematic part is the side...
OK, I'll go with 4 quarts in the crankcase and 1/2 quart in the small filter. Total=4 1/2 quarts. Thanks for all the help.
Yes, I read your post. Good information thanks. But I'm still confused as to how many quarts of oil I should use. I have the shorter WIX filter so...
This is getting confusing. Some say 4 quarts and some say 5, both with a filter. Here's a pix of the stick I have. From the flange to the tip is...
I swapped in a Buick Oddfire into my 57 Willys PU. Not sure what it came out of. Anyway, I put 5 quarts of oil in it along with a new filter and...
I have the same resouviors and the same leak. I've changed the o'ring numerous times which didn't help. I think the clamp is the problem, it wants...
I've used Comp Cams for years, but the 252H kit I bought for my Dauntless rebuild was a disappointment. One of lifters had a damaged component...
I'll take the fuel pump heat shield if still available.
Me too. Go with the TA Performance piece. You won't be disappointed.
You can contact Mikes Carburetor and see if he has one. They always had everything I was looking for....
My Oddfire has a boss on the block with the dipstick hole drilled. I don't know what this engine came out of. Added: There is not tube. The...
Not a CJ, but very similar routing (It a 57 Willys PU) You can see the switch in this picture. [img]
Separate names with a comma.
