1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by jb3b

  1. jb3b
    Post

    Jeep Tops - Past and Present - A Partial List

    I know this is an old thread but I just bought this one.The fiberglass top is good,the metal cab parts have minor rust,all glass is intact except...
    Post by: jb3b, Jan 19, 2022 in forum: Early Jeep Restoration and Research
  2. jb3b
    Post

    What To Use To Flush Out My Dana 25 Differential

    Thanks guys.Both axles are off on jack stands and had been sitting for unknown amount of time.The gear oil was clean with no crud in it.Just...
    Post by: jb3b, Jul 20, 2021 in forum: Flat Fender Tech
  3. jb3b
    Thread

    What To Use To Flush Out My Dana 25 Differential

    I'm cleaning up my dana 25 and 44 to install on my 3b.I opened up the covers ,both visually look good and rotate freely with no noise so I'd...
    Thread by: jb3b, Jul 5, 2021, 6 replies, in forum: Flat Fender Tech
  4. jb3b
    Post

    Ebay Floor Panels

    :watch:
    Post by: jb3b, Aug 13, 2020 in forum: Early CJ5 and CJ6 Tech
  5. jb3b
    Post

    Best Way To Free Up Rusted Trans Gearing

    When I pulled the tower off and saw the rust I expected some water and yes it came out crystal clear.Petro products float on water,knowing this...
    Post by: jb3b, Aug 7, 2020 in forum: Builds and Fabricators Forum
  6. jb3b
    Post

    Best Way To Free Up Rusted Trans Gearing

    I drained both trans and transfer case .Water than sludgy fluid but no metal chips.Looks like a rebuild this winter.
    Post by: jb3b, Aug 7, 2020 in forum: Builds and Fabricators Forum
  7. jb3b
    Post

    Best Way To Free Up Rusted Trans Gearing

    Could be the reason last tag was 1975.At least its in neutral.What about a rebuild kit and do you think its seized in the case ?
    Post by: jb3b, Aug 1, 2020 in forum: Builds and Fabricators Forum
  8. jb3b
    Post

    Best Way To Free Up Rusted Trans Gearing

    Yes it's a T-90
    Post by: jb3b, Aug 1, 2020 in forum: Builds and Fabricators Forum
  9. jb3b
    Thread

    Best Way To Free Up Rusted Trans Gearing

    I've finally pulled the tub off my 54 3b and before pulling trans would like to have everything freed up.The rear,front diff,transfer case,e brake...
    Thread by: jb3b, Aug 1, 2020, 9 replies, in forum: Builds and Fabricators Forum
  10. jb3b
    Post

    What Did You Do To Your Jeep Today?

    Something I did for my jeep,drove to Wheelie's to pick up a f head and box of spare parts.Nice meeting you Dave and thanks again
    Post by: jb3b, Jun 28, 2020 in forum: Builds and Fabricators Forum
  11. jb3b
    Post

    Oil Filter Bracket/f 134

    Thanks Pete
    Post by: jb3b, Jun 20, 2020 in forum: Early Jeep Restoration and Research
  12. jb3b
    Post

    Oil Filter Bracket/f 134

    Can anyone post a pic of the cannister bracket and how it mounts to block ? My 54 had it mounted on driver side fender- snow plow pump ?
    Post by: jb3b, Jun 20, 2020 in forum: Early Jeep Restoration and Research
New Posts