has NOBODY done this? is there really NO advice on this?
I have a T5/D300 set up... :? who's done it? :? any tips? :? is a extended input shaft necessary? (i swear i've heard it is not, but i can't...
understood sparky, i apologize for the mis-communication... JUST A COUPLE QUESTIONS HERE (with my current scenario), NOT RECCOMENDATIONS:...
your particular fuel gauge is different: F - fill it up E - enough R)R)R) no? not funny?
can you look at insurance policies on it? even old ones if you have them? in ca they go by vin's.
MANY here preach about the BDS lift. i do not have experience with it. i personally will be putting a 2.5 yj lift on in the near future, but i...
i was thinking of doing this as well-looking for about one inch of body lift. i know the 55-75's have the hard rubber or plastic, but the 76-up...
may as well wait until an axle breaks to replace it with an upgrade?
i have a lock rite in my d30 front. haven't broken it/axles/r&p...yet. i'd say it's strong enough for a locker, especially for the added...
not sure on price. blasting and powdercoating wheels (they were true spoke wheels off our 64 mgb) was $50 each. i would think painting should be...
i'm a believer of changing, running it around a bit, churning up any other gunk that may not have come out in initial drainage...however, it can...
same thing happened to me. i had a msd ignition and coil. ran great, pulled out 2 rigs, then i went to leave and big backfire, wouldn't start,...
NO, i do not have pics, right now... i will post today or next couple days. someone looked at my leaf springs and told me that i had stock...
Separate names with a comma.
