Thank you, thank you, thank you. I will learn to live with it and maybe one day I will install Saginaw steering.
1962 f134 fresh off frame build. I have 31x10.50x15 tires and a completely rebuilt Ross steering system from the knuckles up. It is very hard to...
My old pinion seal says ASD 142235. Is this a Willys part number? Came from a 3B D25. Anyone know a National equivalent ? Thanks.
The new bearing will be the front pinion bearing. I dinged the original and instead of taking a chance I decided to replace it. Might make my...
Carrier installed with a little dead blow hammer persuasion. Pinion preload is 10"# as best I can tell with my little torque wrench. I have a new...
Second attempt .[IMG] [IMG] [IMG]
I'll check everything again tomorrow. I'll try to get better photos. I don't understand the question about how tight the carrier bearings are. Thanks
[ATTACH] [ATTACH] Here are photos of the contact pattern. The ring gear backlash is .003. What do you think? Thanks
The gears were used in a complete axle that I bought. I don't know the history but the teeth on both R&P looked good but there was some slack...
I will install and check contact pattern.
Sorry, 5.38
Both gear ratio's are 5.88. The R&P are not a matched set. When I opened the differential the wear pattern actually looked good. I will try to...
what will happen if I run a front axle with mismatched ring and pinion numbers?
Separate names with a comma.