Had a little accident this week-end. Everyone is ok dont worry :) Damage is very limited (i'm lucky). Windsheild frame was bend a little. I have...
Dont know. i just use part from chevy and ford to swap out to a internal lock
Maybe a little late on the topic. But there also an upgrade to a internal lock, way stronger than the 5-6 bolts ones...
Been there before on my 360....sometime it goes in on first trial...sometime on after 50 try...
Dana 20 transfert could be a pain to shift. I normaly put the jeep in reverse, goes 1-2 feet, push the clutch before it stop. You need to unload...
Part start to come in. So far i've received the rebuilt kit for the dana 300, the rear output shaft and the correct yoke to get on the flange....
I would stay away....axle shaft are a pain to find....
You could have re-usable hose and fiting from that hydrolic shop. That way you need only a 2-3 feet spare hose with two spare fiting.
I know that is hard to do, but you have to try to align the both rod end. Other you may have problem with the draglink moving left to right on the...
Love the effect of the green rock light. they dont bling you has white one do. Also pratical when walking around the jeep [ATTACH]
[MEDIA]The Ls love playing in the snow. I know where i will be able to use the extra gear with the dana 300. Below 3000rpm that engine is...
Hello its me again…. always something you want to improve, but this one is a major but a ending one for the mechanical part of the jeep. Got the...
That some buggy…wo road manner are not important. And i wouldnt rin tie rod end in a 42" tire boggy ahaha
Been having tie rod for 10 years with my ram assist and the clamp and i never had any sort of problem. If you parallel both the link between wheel...
That's a good move. Also you will a good balance in the force. Steering box are always stronger when turning to the the right. A ram is always...
Separate names with a comma.
